80 meters is starting to come in slowly but surely and it is just a quiet as
the upper bands. This radio is really amazing me.
I used to read abt tentec and hear abt tentec from tentec users and thought,
sure it is, sure it does.
Well, now I are one and *it is* and *it does*.
BTW anyway of updating this series B to a series C or is there any advantage to
doing so?
73 fer nw es gud DX,
QSL VIA: BUR, LotW, e-QSL
Bob AD5VJ(AAR6VM)
Old calls: WY5L/KH3-KE5CTY-N5IET
http://www.ad5vj.com/
Member: CTDXCC, NTCC, STXDXCC
FISTS: # 12637, SKCC# 2369
10X# 37210, FP#-1141
SMIRK#-5177, RARS #-149
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of AD5VJ Bob
> Sent: Friday, December 22, 2006 1:15 PM
> To: 'Discussion of Ten-Tec Equipment'
> Subject: Re: [TenTec] Omni D series B
>
> Well that was SSB.
>
> Now as far as CW is concerned...
>
> First let me say that I love my IC-775, it is as I put on the
> reviews, the best radio I have ever owned as far as Dxing is
> concerned.
>
> Only problem so far with the OMNI D series B, is if there is
> not signal on a particular frequency, it is so quiet compared
> to the ICOM (white noise) I am used to, I keep checking the
> A/B switch because I think I have the A/B switch in the
> center (or off) position.
>
> I also was compelled to check the s meter readings a few
> times, thinking for sure the OMNI D series B must be
> suffering from less sensitivity than the ICOM because I don't
> hear noise from it. But, the S meter readings are
> consistently 3 S units higher.
>
> A lot of QSB on 20 today. Which I am using as a matching
> factor as well. Right now I am on 14016.16 listening to
> Florida and Canada, the TenTec OMNI D series B is reading the
> signals even when the QSB takes them away from the ICOM
> receiver. Now that is simply astounding.
>
> Both rigs are set to max selectivity and the ICOM is set to
> the second PREAMP.
>
> I don't have a "second" PREAMP on the OMNI to turn on. But
> then again, I don't see a need to have one. Perhaps I will
> buy an external one just for grins.
>
> AMAZING difference. So this is what a DX radio sounds like.
>
> Don't tell me it got even better with the series following
> the "B" that would be hard to imagine for sure.
>
> The *real* test (the bottom line for me) will come after
> dark on 80 es 160 meters :0)
>
> Is it dark yet??
>
> 73 fer nw es gud DX,
> QSL VIA: BUR, LotW, e-QSL
> Bob AD5VJ(AAR6VM)
> Old calls: WY5L/KH3-KE5CTY-N5IET
> http://www.ad5vj.com/
>
> Member: CTDXCC, NTCC, STXDXCC
> FISTS: # 12637, SKCC# 2369
> 10X# 37210, FP#-1141
> SMIRK#-5177, RARS #-149
>
>
>
>
>
> > -----Original Message-----
> > From: tentec-bounces@contesting.com
> > [mailto:tentec-bounces@contesting.com] On Behalf Of
> > davkozy@comcast.net
> > Sent: Friday, December 22, 2006 12:35 PM
> > To: Discussion of Ten-Tec Equipment
> > Subject: Re: [TenTec] Omni D series B
> >
> > WELCOME TO THE WORLD OF TEN TEC!!!
> >
> > --
> > Regards, DAVE, KB9EPL
> >
> >
> > -------------- Original message --------------
> > From: "AD5VJ Bob" <rtnmi@sbcglobal.net>
> >
> > > Sent this to the wrong thread before:
> > >
> > > Some of you guys asked me to keep the reflector updated on
> > the "new to
> > > me" OMNI D series B transceiver.
> > >
> > > Well it is all hooked up and ready for some A/B testing
> > against my IC-775.
> > > Already I like the audio better.
> > >
> > > So far, for some reason given the same signal, it seems to
> > stand out
> > > in the room better.
> > >
> > > Only thing I can tell that is wrong with it so far, is that the
> > > S-Meter light does not light up.
> > >
> > > Using the A/B switch switching the rigs instead of
> > antennas, my whole
> > > family (including me) is amazed at the clarity of the
> audio on this
> > > rig. Even though the signal strengths are the same, the
> > audio is much
> > > more copyable on the TENTEC.
> > >
> > > 73 fer nw es gud DX,
> > > QSL VIA: BUR, LotW, e-QSL
> > > Bob AD5VJ(AAR6VM)
> > > Old calls: WY5L/KH3-KE5CTY-N5IET
> > > http://www.ad5vj.com/
> > >
> > > Member: CTDXCC, NTCC, STXDXCC
> > > FISTS: # 12637, SKCC# 2369
> > > 10X# 37210, FP#-1141
> > > SMIRK#-5177, RARS #-149
> > >
> > >
> > >
> > >
> > >
> > >
> > > > -----Original Message-----
> > > > From: tentec-bounces@contesting.com
> > > > [mailto:tentec-bounces@contesting.com] On Behalf Of Barry Gross
> > > > Sent: Friday, December 22, 2006 5:43 AM
> > > > To: Discussion of Ten-Tec Equipment
> > > > Subject: Re: [TenTec] Omni D series B
> > > >
> > > > Actually, you might contact Ten-Tec if you're looking for
> > a manual.
> > > > They may still have new manuals available at a
> reasonable price,
> > > > without raising the perennial copyright question.
> > > >
> > > > GL/73,
> > > > Barry N1EU
> > > >
> > > > On 12/22/06, AD5VJ Bob wrote:
> > > > > Is there a manual online or does anyone have a pdf manual
> > > > for the OMNI D series B?
> > > > >
> > > > > Also I am on rigpix and there is conflicting
> information - one
> > > > > page says 100W out and the other says 200W output.
> > Which does it have?
> > > > >
> > > > > 73 fer nw es gud DX,
> > > > > QSL VIA: BUR, LotW, e-QSL
> > > > > Bob AD5VJ(AAR6VM)
> > > > > Old calls: WY5L/KH3-KE5CTY-N5IET http://www.ad5vj.com/
> > > > >
> > > > > Member: CTDXCC, NTCC, STXDXCC
> > > > > FISTS: # 12637, SKCC# 2369
> > > > > 10X# 37210, FP#-1141
> > > > > SMIRK#-5177, RARS #-149
> > > > >
> > > > >
> > > > >
> > > > >
> > > > >
> > > > > _______________________________________________
> > > > > TenTec mailing list
> > > > > TenTec@contesting.com
> > > > > http://lists.contesting.com/mailman/listinfo/tentec
> > > > >
> > > > _______________________________________________
> > > > TenTec mailing list
> > > > TenTec@contesting.com
> > > > http://lists.contesting.com/mailman/listinfo/tentec
> > > >
> > >
> > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|