TenTec
[Top] [All Lists]

Re: [TenTec] Omni D series B

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni D series B
From: davkozy@comcast.net
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 22 Dec 2006 18:35:00 +0000
List-post: <mailto:tentec@contesting.com>
WELCOME TO THE WORLD OF TEN TEC!!!

--
Regards, DAVE, KB9EPL


-------------- Original message -------------- 
From: "AD5VJ Bob" <rtnmi@sbcglobal.net> 

> Sent this to the wrong thread before: 
> 
> Some of you guys asked me to keep the reflector updated on the "new to me" 
> OMNI 
> D series B transceiver. 
> 
> Well it is all hooked up and ready for some A/B testing against my IC-775. 
> Already I like the audio better. 
> 
> So far, for some reason given the same signal, it seems to stand out in the 
> room 
> better. 
> 
> Only thing I can tell that is wrong with it so far, is that the S-Meter light 
> does not light up. 
> 
> Using the A/B switch switching the rigs instead of antennas, my whole family 
> (including me) is amazed at the clarity of the audio on 
> this rig. Even though the signal strengths are the same, the audio is much 
> more 
> copyable on the TENTEC. 
> 
> 73 fer nw es gud DX, 
> QSL VIA: BUR, LotW, e-QSL 
> Bob AD5VJ(AAR6VM) 
> Old calls: WY5L/KH3-KE5CTY-N5IET 
> http://www.ad5vj.com/ 
> 
> Member: CTDXCC, NTCC, STXDXCC 
> FISTS: # 12637, SKCC# 2369 
> 10X# 37210, FP#-1141 
> SMIRK#-5177, RARS #-149 
> 
> 
> 
> 
> 
> 
> > -----Original Message----- 
> > From: tentec-bounces@contesting.com 
> > [mailto:tentec-bounces@contesting.com] On Behalf Of Barry Gross 
> > Sent: Friday, December 22, 2006 5:43 AM 
> > To: Discussion of Ten-Tec Equipment 
> > Subject: Re: [TenTec] Omni D series B 
> > 
> > Actually, you might contact Ten-Tec if you're looking for a manual. 
> > They may still have new manuals available at a reasonable 
> > price, without raising the perennial copyright question. 
> > 
> > GL/73, 
> > Barry N1EU 
> > 
> > On 12/22/06, AD5VJ Bob wrote: 
> > > Is there a manual online or does anyone have a pdf manual 
> > for the OMNI D series B? 
> > > 
> > > Also I am on rigpix and there is conflicting information - one page 
> > > says 100W out and the other says 200W output. Which does it have? 
> > > 
> > > 73 fer nw es gud DX, 
> > > QSL VIA: BUR, LotW, e-QSL 
> > > Bob AD5VJ(AAR6VM) 
> > > Old calls: WY5L/KH3-KE5CTY-N5IET 
> > > http://www.ad5vj.com/ 
> > > 
> > > Member: CTDXCC, NTCC, STXDXCC 
> > > FISTS: # 12637, SKCC# 2369 
> > > 10X# 37210, FP#-1141 
> > > SMIRK#-5177, RARS #-149 
> > > 
> > > 
> > > 
> > > 
> > > 
> > > _______________________________________________ 
> > > TenTec mailing list 
> > > TenTec@contesting.com 
> > > http://lists.contesting.com/mailman/listinfo/tentec 
> > > 
> > _______________________________________________ 
> > TenTec mailing list 
> > TenTec@contesting.com 
> > http://lists.contesting.com/mailman/listinfo/tentec 
> > 
> 
> 
> _______________________________________________ 
> TenTec mailing list 
> TenTec@contesting.com 
> http://lists.contesting.com/mailman/listinfo/tentec 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>