Your assuming that you can be heard. In weak signal work where you are only
hearing part of the audio anywhere, compression really helps.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Richard Robinson" <nw4p@adelphia.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, December 22, 2006 1:12 PM
Subject: Re: [TenTec] Orion 1
> Gentleman,
> Following this conversation on output of audio...I personally think that
> maintaing clean audio is what really stands out on SSB... To hear loud,
> peaked, compressed, clipped,etc. audio to me, is irritating... I would
> rather hear a 100 watt signal properly transmitted than a 1500 watt
> splatter...There are some nice, high output signals out there but
> occasionally these come along... I know some individuals use an amp that
in
> tuned to put out 1500 watts on the valleys with 2000-2500 on the peaks..
> Anyway, just had to jump in....
> Best to all and 73, Richard NW4P
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|