TenTec
[Top] [All Lists]

[TenTec] Pegasus Serial Port Control

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: [TenTec] Pegasus Serial Port Control
From: "Mark Erbaugh" <mark@microenh.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 10 Dec 2006 17:52:17 -0500
List-post: <mailto:tentec@contesting.com>
I'm messing around writing a Linux control program (in Python) for my
Pegasus.  It's been a while since I worked on my Windows/Delphi version.

Anyways, it seems that whenever I send the Pegasus the command to enable
keep alive (#9 <cr>), I get a Z <cr> response (invalid request). I don't get
the Z for disable keep alive (#8 <cr>) or any other # digit <cr> command.
I've verified this, both from within my Python program (which seems to be
mostly working) and from a simple serial port terminal program (GtkTerm).

I am running version 1.201 (last) of the Pegasus firmware. I haven't yet
determined whether the radio expects keep alives after sending the #9
command.

73,
Mark


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>