To: | tentec@contesting.com |
---|---|
Subject: | [TenTec] OT: WB0CW's Mark V |
From: | Bill Tippett <btippett@alum.mit.edu> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Thu, 07 Dec 2006 09:12:45 -0500 |
List-post: | <mailto:tentec@contesting.com> |
N1EU wrote: >Phil, if you're getting "murdered" by overload with MkV Field, I'd first check that the receiver is adjusted properly as Denny suggested. First thing I would check is that NB is turned Off AND fully CCW. If that helps, W8JI has a permanent fix for this below: http://www.w8ji.com/ft1000mk_v.htm Second check is that IF Gain in hidden menu 9-1 is not set too high. Simple test is use a calibrated 50 uV source like Elecraft's XG1 and set IF gain so the S-meter reads around S9 on 40m with 500 Hz BW and preamp off. 73, Bill W4ZV P.S. While you're at it, install W8JI's or Inrad's key click fix for the Mark V if not already done. 73, Bill W4ZV _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Noise Reduction Setting, K4IA |
---|---|
Next by Date: | [TenTec] Correction Re: OT: WB0CW's Mark V, Bill Tippett |
Previous by Thread: | [TenTec] Hopefully, my Christmas present will be ..., Dennis OConnor |
Next by Thread: | [TenTec] Correction Re: OT: WB0CW's Mark V, Bill Tippett |
Indexes: | [Date] [Thread] [Top] [All Lists] |