TenTec
[Top] [All Lists]

Re: [TenTec] Model 260 PSU problem

To: tentec@contesting.com
Subject: Re: [TenTec] Model 260 PSU problem
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
Reply-to: geraldj@storm.weather.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 01 Dec 2006 17:01:45 -0600
List-post: <mailto:tentec@contesting.com>
On Fri, 2006-12-01 at 22:41 +0000, Steve Hunt wrote:
> Jerry,
> 
> Thanks for your advice.
> 
> I have catalogues for all the main UK component distributors, but none stock 
> a diode bridge in the same package as the one in the Model 260. It's a 
> package I've never seen before. Take a look at:
> 
> http://hoffind.com/ipw-web/productpage/images/VT400T.JPG
> 
> So I guess I'll just have to adapt the more usual 1" square packaged part.
> 
> 73,
> Steve G3TXQ

I've seen that package in catalogs. Never in the solid though. Likely
the flange matches a TO-3 case. So I guess you need a new hole in the
heat sink right in the middle.
-- 
73, Jerry, K0CQ,
All content copyright Dr. Gerald N. Johnson, electrical engineer

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>