Interesting question. I've wondered about this for a while and had an
opportunity to try my Centaur amplifier with a FT-2000 (in place of my
usual Paragon) in full QSK mode this weekend.
What I did was hook an external keyer to the "key in" jack of the
amplifier and hooked the amplifier "key out" to one of the FT-2000 key
jacks, thus taking advantage of the sequencing in the TT amp. The
FT-2000 key jack was set to operate without the internal keyer. It
seemed to work fine and reports were that the keying sounded the same
either semi or full QSK.
I did have a xmit lock-up but only on 80 m, so most probably a local
grounding issue, not a systematic problem of the connections.
Good to know about the possibilities!
73, Joel
Joel R. Hallas, W1ZR
Ken Kinyon wrote:
>If any one is using the Pro III with a Ten-Tec Titan III. I have some questions
>about what hook up you use. Particularly with QSK CW.
>Thanks,
>Ken W7TS
>
>-------------------
>Kenneth E. Kinyon
>34 Princeton Circle
>Longmont, CO 80503-2106
>-----------------------
>E-mail: W7TS@comcast.net
>------------------
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|