On Sat, 2006-11-18 at 08:48 -0500, Vince Santis wrote:
> Good morning,
>
> I'm trying to get a newly acquired Corsair II on cw. I can't get my
> paddles to close the T/R switch. The radio works fine on SSB. I'm in the
> paddles jack, keyer speed is up, and the mode is set for cw. What am I
> missing?
>
> TIA,
>
> Vince Santis, N1VS
> Winsted, CT 06098
For certain Keyer Out must be connected to Key with a jumper, short or
long. RCA to RCA. A new Corsair II came with a very short jumper. It can
be feet long, probably should be shielded. Then my manual is not clear,
I suspect you need to ground PTT or to enable VOX to transmit on CW. And
to decide on QSK or not to QSK.
--
73, Jerry, K0CQ,
All content copyright Dr. Gerald N. Johnson, electrical engineer
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|