I have an Orion1 running 2.059d. I have not used it mmuch due to work
schedules, but this afternoon I noticed that after a while of operating, the
control panel freezes up. The rig is still working when this happens, I just
cannot change anything since none of the controls work. I performed a master
reset, but it still happens. I turn the rig off and back on, and everything
works fine for a while. Anyone else experience this ? Any ideas ?
Danny N5NBK
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|