TenTec
[Top] [All Lists]

[TenTec] O2 Receive Insensitivity

To: tentec@contesting.com
Subject: [TenTec] O2 Receive Insensitivity
From: ac9s@mchsi.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 21 Oct 2006 02:57:57 +0000
List-post: <mailto:tentec@contesting.com>
I have had a strange thing happen with my O2.  I have been impressed with the 
sensitivity of the receivers, unlike my Pro.  However, in the last day or two 
the main receiver seems to have gone very deaf. However, with the pre-amp on I 
receive signals strongly.  It is currently 9:30pm on Friday evening and I am 
listening to JARTS on 20 RTTY.  With no pre-amp I can barely hear AH7C and 
there is no indication of band activity on the band scope.  With the pre-amp 
on AH7C is registering S9 and there are a whole bunch of copyeable RTTY 
signals showing strongly in the band scope.  In the past the pre-amp seemed to 
give me about an S unit or so of increase on the S meter.  Now, it is the 
difference between nothing and S9.  The sub receiver appears to be hearing 
about the same as the main with the pre-amp, but of course I cannot see its 
signals on the band scope.

Has anyone else experienced these symptoms?  Is it possible I could have had a 
static discharge on one of my wire antennas zap the main RX front end and not 
bother the pre-amp if it was turned off?  I haven't normally used it.  I am 
listening with the AGC set to the minimum of .37uv.

My first thought was that the higher bands are completely dead at the bottom 
of the cycle, but since I am hearing so well with the pre-amp on there appears 
to be something else at play.  

Any thoughts anyone - before I contact Ten Tec?

Thanks --- 

Keith
AC9S
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>