Hi Dick,
The answer to your question is yes and no!!
If your dial accuracy is off by 300 hz, then yes, you calibrate the
master oscillator, which is either a TCXO or an oven heated xtal oscillator.
But I assume your talking about on SSB? If so, then you have to
calibrate the BFO frequencies, and there are five of them. The manual
has a step-by-step procedure for doing that. It is, however, time
consuming. For either case, you will need a well calibrated frequency counter.
I have just done this on both of my Omni 6+ rigs and it takes about 2
hours to complete one.
Tom - W4BQF
At Thursday 09:54 PM 10/12/2006, you wrote:
>Is there a simple adjustment to calibrate the Omni 6+.?
>Mine is off about 300hz and is just annoying enough to want to try and adjust
>it for more accuracy.
>Thanks
>Dick K9RT
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|