Thanks to Carl for adjusting his program so that it works great with the new
Orion II firmware.
Have not seen others approach the problem in such an aggresive manner..
Thanks Carl for your great support
Carl Moreschi <n4py@arrl.net> wrote:
There seems to be an issue with some Orion II's with 2.037j that causes the
baud rate to be off a little. The fix is to set the baud rate at 56000 baud
instead of 57600.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "David E. Shelton"
To:
Sent: Sunday, October 08, 2006 7:46 PM
Subject: [TenTec] Orion II firmware problems
> Is it just me or does the current version of FW 2.037j have some issues
with
> computer interfacing the Orion II. I can't get DX4WIN, MixW, WriteLog, or
> several others to interface smoothly with 2.037j. I reverted back to 2.034
> and the problems are gone. When will this be fixed? I looks like the FW
was
> released September 7. This is a fairly significant problem that would
affect
> about everyone with these rigs. Is there a work around other than using
> 2.034? Thanks,
> David, N4IN
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
Michael W. Elliott, CISSP
(Certified Information Security Specialist Professional)
THE INSIDE ADVANTAGE -
RETIREMENT - LEISURE, REST and ONLY ELECTRONIC MAIL PAYMENTS
Servant to Bridgett, Collin and all my Creditors
St. Louis County Missouri
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|