Do a battery reset and then a normal reset. You should always do these when
changing firmware levels.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Ben K8DIT" <benk8dit@callatg.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, October 05, 2006 10:39 PM
Subject: Re: [TenTec] TenTec Orion I V2
"Since then, I can´t hear anything on my second receiver. Only noise.
What can I do?"
Bernhard,
Same thing happened to me. I was told to send it in for repair to TT. Ben
K8DIT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|