Well, I finally plucked up courage to do a PTO rebuild on my 20 yr old Corsair
II yesterday - I couldn't stand the "slipping" drive any longer! I used the
TenTec kit, and after a couple of hours work it was all back in the rig and
working well - no slipping and no backlash.
My question: although it no longer slips, the drive now feels slightly
"stiffer" than it did previously - it certainly doesn't feel as "light" as the
drive on my remote VFO which has had hardly any use. TenTec say you can space
the rear plastic retainer off the PTO box using 3 washers rather than 2 if the
action feels rough - I presume this reduces the spring tension on the ball
drive and would make the action "lighter".
Has anyone tried using the 3 washers? Or do you think the action will free up
after a bit of use? I'm keen to get some advice before pulling the retainer off
again .... getting it back on is the hardest part of the job!
Grateful for any help.
Steve G3TXQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|