TenTec
[Top] [All Lists]

Re: [TenTec] Orion and rtty

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion and rtty
From: Phil Howlett <w9xx@hughes.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 25 Sep 2006 21:47:12 -0400
List-post: <mailto:tentec@contesting.com>
A menue selection in "other" allows operator selection of mark either  
high or low.

Shift is fixed at 170Hz.

The Orion works well on RTTY, especially with the 300Hz filter.

W9XX

On Sep 25, 2006, at 9:28 PM, Art wrote:

> There is limited advice in my Orion manual, and the rtty pdf isn't all
> that clear. I want to use true fsk.
>
> Would I be correct in assuming the rtty in acc1 is open equals mark,
> grounded equals space? That is to say, will my Writelog interface, the
> one in the WL helpfile that I built, work just fine on the Orion?  
> Is the
> offset an automatic 170 Hz or can I set it someplace that I haven't  
> found?
>
> Q2. Is it the same for my brother's Omni 6?
>
> Tnx 73 Art
> k6xt at arrl dot net
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>