TenTec
[Top] [All Lists]

[TenTec] V2.059d AGC settings for Orion I

To: tentec@contesting.com
Subject: [TenTec] V2.059d AGC settings for Orion I
From: "Mark DeBord" <markinkpt@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 24 Sep 2006 13:02:56 -0400
List-post: <mailto:tentec@contesting.com>
Well, since everyone has had a few weeks to play with the new AGC settings 
on the new firmware V2.059, I was wondering what everyone has settled with 
on the AGC settings on each speed (slow, med, fast). I have seen settings 
for the O II, but wonder if you guys on the O I are doing the same thing. I 
am still hearing the digital artifacts at times, but adding a little hang 
time helps, but does not cure 100% (it is not heavy artifacts; just small 
"peaks" that occurs at voice/noise peaks; which is what I assume the result 
of the new AGC delayed reaction in this release).

Also, how is everyone liking the TX audio? Do you think it is back to 
"normal" as it was in V1 on the low-end? I now have all my settings, 
including mic gain, W2IHY settings, EQPlus settings, as I did in V1.

The code is still very stable for me.

Thanks for the feedback,

Mark KA4ICK


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>