TenTec
[Top] [All Lists]

Re: [TenTec] Announcing N4PY Paragon Chip now available

To: n4py@arrl.net, tentec@contesting.com
Subject: Re: [TenTec] Announcing N4PY Paragon Chip now available
From: "M. P. Haynes" <k4beh@juno.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 23 Sep 2006 11:57:53 -0400
List-post: <mailto:tentec@contesting.com>
Carl,

I have a Paragon with the Giehl chip in it.  I like the chip very much
compared with the original Ten-Tec version.  What does your chip do that
Jack's doesn't besides the front panel receive antenna control which
isn't important to me?   

73,

Pat - K4BEH

On Mon, 18 Sep 2006 08:25:23 -0400 "Carl Moreschi" <n4py@arrl.net>
writes:
> I have developed a new Paragon EPROM chip for all Paragons.  The new 
> chip
> greatly enhances the operation of the Paragon.
> 
> Highlites of the new function
> 
> Two band stacking registers for each ham band
> Icom CI-V serial port operation for logging programs
> Up/Down arrows move to next band by mode
> Frequency Scan
> Quick Split
> Provisions for front panel receive antenna control
> Special memory tune by mode
> 
> The chip is available for $30.  Send an email to me at n4py@arrl.net 
> for
> more information.
> 
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 
 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>