FWIW
I just noticed that I can no longer switch between software and hardware
noise blankers by holding the NB button. Have to go to RX menu to turn HW
NB on or off.
Also, I have headset only "popping" or "clicking" keying artifacts that I
never had with 2.032 or 2.034 (on all bands). On 10 meters the sidetone is
accompanied by a (near 60 hz) hum that was never there before. No changes
other than firmware. Oh...my spot and side tone volumes are very
different...before they were the same.
I like the agc changes, but (contrary to many on the list) I find the NR no
better and these new glitches are very, very annoying.
Probably ought to go back to .034 and pretend I am happy.
I have forwarded these concerns to ditsnbits.
73, Bob K5SM
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|