Hey fellow. What software programs can u use with the V. I have a omni VI with
the 305 converter. What programs can I use? I used N4PY before with Jupiter but
not on omni VI. Tnxs Roger, W4IV
---------- Original Message ----------------------------------
From: J A Crux <jac.trademarks@tiscali.co.uk>
Reply-To: jac@patents.freeserve.co.uk,Discussion of Ten-Tec Equipment
<tentec@contesting.com>
Date: Tue, 29 Aug 2006 18:29:04 +0100
>I still use my Omni V.9 every day. Yes, the keypad now does things it did not
>do before.
>For me the biggest improvement is being able to use the serial port. For
>example I now get to enter data directly into my logging programme. But that
>does require a fairly straightforward hardware mod that I have never
>regretted making.
>
>If I was to modify another Omni V (and the local club has one sitting there
>doing nothing) I would also check if the NVRAM X204 memory chip is socketed.
>It gets chronic amnesia after a lot of use. I cut the dead one out and fitted
>a turned pin 8 pin DIL socket in my Omni. I also bought a few replacement
>chips (from Newark.) The CMOS version is 24C04P and it works fine. In fact I
>have not had to swap one despite many more years of use.
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|