Hi John,
Yes,... You can use computer control and the remote pod at the same time.
You have to connect the computer to pin 2 (txd) and pin 3(rxd) and pin 7
(gnd)
The remote pod must be connected to pin 6 and 8, the 5 Volt for the remote
pod is on pin12.
These are the pins of the 25p sub D connector on the back of the Omni 6
You see for yourself on 4-45, 4-46 in the Omni 6 manual this is the diagram
of the TX Audio board.
This setup is working fine here for many years.
73 Gert, PA3AAV.
----- Original Message -----
From: john <johnmb@nc.rr.com>
To: <tentec@contesting.com>
Sent: Sunday, August 20, 2006 5:21 PM
Subject: [TenTec] Omni VI/ computer and remote tuning pod
> I'd like to use my Onmi VI with computer control AND the remote
> tuning pod. I also have the model 305 level convertor.
>
> I KNOW someone's been there before... can all this work together ? (The
> remote tuning pod and the computer control?
>
> Thanks!
> John K5MO
>
>
>
>
> --
> No virus found in this outgoing message.
> Checked by AVG Free Edition.
> Version: 7.1.405 / Virus Database: 268.11.3/423 - Release Date: 8/18/2006
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|