TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI+ question

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI+ question
From: "RB" <K9RB@bellsouth.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 19 Aug 2006 12:43:56 -0400
List-post: <mailto:tentec@contesting.com>
The roofing filter mod/addition from INRAD does not require any soldering
except for power. The rest of the connections are all provided for with mini
coax and plugs on the filter accessory board. A very straightforward and
easy installation. SMD has nothing to do with the installation, so not to
worry, Gary. T's a very well thought out and designed addition that is worth
every penny. Installation takes a maximum of a half hour. 
73, -=Rog-K9RB=-  (Mine is a 1998 vintage Omni VI Plus model 564 with SMD
technology)

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Gary Tuck
Sent: Saturday, August 19, 2006 11:28 AM
To: Ten Tec Mailing List
Subject: [TenTec] Omni VI+ question

I understand that as the VI+ evolved, some boards were constructed  
with SMD technology.  Does anyone know if the RF board (underside of  
rig near finals unit) was built with SMDs in later rigs?  If I do  
acquire a late model Plus, I would want to install the InRad roofing  
filter but am not anxious if it means soldering onto a SMD board.  My  
past experiences do not inspire much confidence.    : )

tnx, Gary W7TEA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>