Thanks Bob for adding your voice to the versions being used... Jim Reed.
----- Original Message -----
From: Bob Cunnings
To: Discussion of Ten-Tec Equipment
Sent: Tuesday, July 18, 2006 13:17
Subject: Re: [TenTec] What version?
I'm using 2.056, runtime stability was paramount for me. With 1.372 my
rig locked up from time to time, but 2.056 is rock solid. Since I'm a
CW op the 2.056 issues often discussed here don't impact me, and I
have grown accustomed to the minor display oddities (ragged
justification of certain lines of text, and funny offset in sweep
display in UCW mode).
Bob NW8L
On 7/18/06, J.Reed <jhreed@chilitech.net> wrote:
> Good morning Orion (1) owners-users... Since I'm a relatively new
> Orion-1 owner (3-months), I would like to conduct a survey as to which
> version of firmware each user has found to satisfy their 'needs', and why.
>
> I started out with version 2.056 but decided, after reading the Ten-Tec
> group, to try ver 1.373b5 as an alternate quest for cleaner audio, etc. It
> seems to work well for me so I throw this question out to the group at
large..
>
> "What version are you using and why?" W3RYJ, Jim Reed.
>
> PS: Digital, SSB and CW modes most used.
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|