Yes, try to update the firmware to the latest version from the tentec site
rfsquared. Even if you are already at this version, see if you can load
that version again. If you can't get the loader to run then you can assume
the OII's serial port is bad.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "G" <goofyham@highstream.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, July 12, 2006 3:26 PM
Subject: [TenTec] ORION2_SteppIR_Interface
> I was hit with lightening the other day and my O2 to SteppIR control box
are no longer on the same page. Normally, when I change the O2's frequency
the SteppIR box changes the beam to the same frequency.
> After the jolt by Mother Nature they aren't talking.
> The SteppIR box works fine in the manual mode.
> My question is. Is there a free down load O2 program I can run and control
the O2? I can take the DB9 off the SteppIR box and connect it to the
computer to see if the computer talks to the O2 to prove the O2 or the
SteppIR box.
> Or is there an easier way to prove the O2's interface isn't the cause.
> Thanks.
> George
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|