Klaus Heintzenberg wrote:
> Orion 2
> s/n 02C10436
> fw 2.032
> Menu-CW-PTT in CW as: MOX
> Internal Keyer ON
>
>
> Choose some band with band-change keypad.
> Set up SSB mode with VOX=ON on one of the bandstacking registers.
> On the next bandstacking register set up the radio in CW mode.
>
> Now go to SSB by band change keypad and make sure VOX is ON
> Then press pad to change to the CW band segment. Then the VOX sign
> on the display changes.
> Now tap on the microphone or whistle into the mic while in CW mode.
>
> My radio then goes into transmit and puts out a constant carrier at the
> preset
> output power level!
> The only way to shut of the carrier is to hit the main power switch.
> Should'nt the VOX be disabled while on CW?
>
> Imagine you changed from SSB to CW. Then, while leaving the room for the
> bathroom, you slam the door shut. That may take the Orion into transmit.
> When you return your amplifier may have gone up in smoke...
>
> Can anybody else reproduce this?
>
> 73, Klaus (DJ6RX)
>
Reproduced here with these variations:
Orion 2
s/n 05C10726
f/w 2.034
CW-PTT as: KEY
Internal keyer: OFF
Looks like a tweak in firmware is needed to remove the potential for
embarrassment. Despite this, although I have only had my Orion for just
six days, it is already clear that it is a very, very fine rig indeed.
73, Pete
G4PLZ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|