As I recall, Most Band Info is on the RS-232 pins..
Dave W7DPW
----- Original Message -----
From: <k7gt@charter.net>
To: <tentec@contesting.com>
Sent: Friday, June 02, 2006 7:43 AM
Subject: [TenTec] internal connectors on OmniVI
> I have need to connect to the inter-board connections on the OmniVI.
Could
> an expert on this radio please help me find, if they exist, a clean
way to grab
> the connections and port them out of the radio. I will be using it,
after
> conditioning, to grab the full set of band info voltages to control
bandpass filters
> and antennas. Obviously, I could cut into one of the ribbon cables or
'wire wrap'
> the new connection around a pin, replacing the mating connector. But,
I would
> like to do it more cleanly and elegantly.
>
> No, I have not yet contacted Tentec. I will do so if no one is able to
assist
> on this reflector.
>
> 73 Allan K7GT
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|