Rich, Are you using the ten tec 305 level converter with it. In checking on
internet it seems the Heathkit converter may work and the Icom ct-17 or
derivative there of. The Ham Radio Delux software has a web site on interfaces
cat and audio. I use a Keyspan usb to ser runs program ok but does not like
anything about switching/ptt. I also have a radio shack which works ok on most
all, Yeasu/Kenwood but does not like my omni 6. You can always take back to rs.
Works fb on 1000mp mark 5. the ten tec model 305 has a mono 1/8inch pug from
back of omni 6 to box then out of 305 by db25 to puter or usb adapter. A lot of
posts this week on these usb adapters. I've just about pulled my last good hair
roots out over this interfacing stuff. Gud lk Roger W4IV
---------- Original Message ----------------------------------
From: "Richard Arland, K7SZ" <richard.arland@verizon.net>
Reply-To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 15 May 2006 23:40:42 -0400
>I finally broke down and picked up a new HP Laptop! It is loaded....and I do
>mean LOADED!
>
>Unfortunately, the only thing it DOESN'T have is an RS-232 port on the back
>(OK, it doesn't have a 3.5 inch floppy drive either...)
>
>I need a USB to RS-232 adaptor but I have received information that not all of
>these adaptors are created equal. Which ones work the best? Anyone have any
>experience with this dilema?
>
>I need guidance...badly, just ask my wife!!
>
>73 Rich K7SZ
>
>PS: The rig I am trying to control is a Paragon-I.
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|