TenTec
[Top] [All Lists]

Re: [TenTec] Orion Band Decoder Output Bug

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion Band Decoder Output Bug
From: "Ron Castro" <ronc@sonic.net>
Reply-to: Ron Castro <ronc@sonic.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 22 Apr 2006 23:07:26 -0700
List-post: <mailto:tentec@contesting.com>
I have also noticed similar types of bugs in the O2, including one I 
occasionally see where two antennas get selected at once.  Changing bands 
fixes the problem, and I haven't considered it serious since I always check 
to see which antenna is selected.

Ron N6AHA


----- Original Message ----- 
From: "Merle Bone" <merlebone@charter.net>
To: <tentec@contesting.com>
Sent: Saturday, April 22, 2006 8:22 AM
Subject: [TenTec] Orion Band Decoder Output Bug


>I have been using the Orion for two years and had not noticed this issue - 
>its a function of how you operate. I use the band decoder output from the 
>Orion to drive a Top-Ten band decoder and two remote antenna switches. They 
>switch 5 antennas onto the Orion, depending on the band. In testing the 
>issues associated with the "mode transfer bug," when using the Orion A>B, I 
>noticed the antenna switch didn't always switch when the B VFO changed 
>frequency. So I did some testing and what I observe is if the B VFO , for 
>instance, is on 20M, in split-mode, the band decoder output of the Orion is 
>switched to 20M. If you use the front key entry pad to put a new frequency 
>on the A VFO, for 40M, and then do an A>B -  the frequency transfers to the 
>B VFO but the band decoder output of the Orion does not change to 40M. It 
>looks like the Orion band decoder output only changes when you use the 
>front keypad to change bands or if you command the Orion remotely, from a 
>program, to go to a new fr
> equency/band.
>
> I don't know if the same logic is in the V2.056 firmware - I haven't 
> checked it. Someone that uses V2.056 may want to check. I'm sure the V1 
> code won't get fixed but this should go on the V2 bug list if it is the 
> same logic in V2 - otherwise you can get a surprise when your amplifier 
> starts to load the wrong antenna!
> 73,
> Merle - W0EWM
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>