Sam
The handbooks should tell you how to
build a pad to drop the output level to properly drive the recorder. If your
shack is quiet, plug a cheap mike into your soundcardand place it near the
radio speaker. Ido this all the time.
Ron
K3MIY
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Denton
Sent: Thursday, April 20, 2006 6:22 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] recording devise for Omni 6+
vcr....dirt cheap these days....
----- Original Message -----
From: "Sam Bridges" <radiobridge@InfoAve.Net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, April 20, 2006 3:18 PM
Subject: [TenTec] recording devise for Omni 6+
> Hello Guys:
> Surely someone has already done this. I have an Omni 6+ and the audio
> out jack on the back is 1 mw at 600 ohms. I am looking for a device to
> record cw from this jack. I prefer a cassette recorder but what I have
> found that could work(?) is in the $100 range. I am hoping for something
> cheaper. The cheap one have no audio input jack or only USB or a built-in
> mic. Any one have experience with this problem please send me a line or
> two off list: kj4zm@arrl.net
> 73s de KJ4ZM Sam
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|