TenTec
[Top] [All Lists]

Re: [TenTec] Subject: Re: Omni CW vs SSB

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Subject: Re: Omni CW vs SSB
From: Ken Brown <ken.d.brown@hawaiiantel.net>
Reply-to: ken.d.brown@hawaiiantel.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 17 Apr 2006 09:10:35 -1000
List-post: <mailto:tentec@contesting.com>
> "Yeah, I've heard that Ten-Tec rigs are great on CW, but on SSB?......"
I heard this before too, and I've never received any audio reports on my 
Omni VI that were anything but good. In fact I have received many many 
reports saying my signal sounds "great" or "the best signal on the net." 
I have played with the mic gain and processor controls while in QSO with 
a friend, whose judgment I trust, and based on that I do believe it is 
possible to crank it up to the point where it doesn't sound as nice. 
That is true of most rigs.

I have also heard that the receive audio is poor, unless you change some 
parts in the audio stages. I have never found the receive audio on my 
Omni VIs lacking, and  am not driven to get inside the radio to change 
anything. The Paragon tone controls, 6 kHz filter selection and AM mode 
selection certainly allow for some better sounding audio with AM or wide 
SSB signals, than you can get with the Omni VI.

By the way, read the manual about the battery on the 705 microphone. 
Depending on which rig you have it connected to, you may not need the 
battery. With my Omni VIs and Paragons the battery is not needed.

DE N6KB

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>