TenTec
[Top] [All Lists]

Re: [TenTec] omni d series c display problem

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] omni d series c display problem
From: Ira Franklin <k4ymq@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 12 Apr 2006 04:01:36 -0700 (PDT)
List-post: <mailto:tentec@contesting.com>
Gustavo, I had very sililar problem with Omni C I used to own, it was a bad 
solder connection on display board
  

lw3ewz <lw3ewz@speedy.com.ar> wrote:
  Dear friends 
i love this rig... but i have a problem 

I need te solution at my display problen in my omni d series c

The display look 1.000 in 7 mhz band. 91.000 in 10 mhz, 09000 in 14 mhz and 21 
mhz and sudenly the display works fine 

what is the problem? and what is the fix or solution?

Sometimes the display works fine and sudenly works bad again..

thanks in advance

Gustavo A. Andrada
lw3ewz
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.375 / Virus Database: 268.4.0/304 - Release Date: 07/04/2006
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


                        
---------------------------------
Yahoo! Messenger with Voice. PC-to-Phone calls for ridiculously low rates.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>