Like John, I've seen this bug well before 2.032, actually since I got my O2
late
December. Code version was 2.025. I called Ten-Tec and told Paul about it. At
that point, he hadn't heard of it before.
Often, a master reset stops it from happening for a while.
I just tried the "NB 2, NR 2, and push NOTCH" method, and it failed.
Lin
WB1AIW
John Nason / NA9U wrote:
> That is strange. This problem as been around since I
> got my Orion V2.029. It is not unique to 2.032.
>
> If its a bug it should happen on all rigs though. Are
> you sure you duplicated the steps?
>
> If so, good for you.
>
> 73,
> John NA9U
>
> --- G <goofyham@highstream.net> wrote:
>
>
>>I'm on 2.031 and it doesn't happen. All's well with
>>my O2.
>>George
>>
>>_______________________________________________
>>TenTec mailing list
>>TenTec@contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|