Yep,
I can reliably reproduce this on my Orion II with version 2.030 software
The Orion II is set up in the following manner:
1 frequency 14201.00
2. Initial setting is in USB
3. Internal Tuner engaged and tuned to frequency (SWR of 1.5)
4. VOX set to on.
5. Sweep is engaged
Next
Switch from USB to UCW (VOX turns itself OFF)
Whistle into the microphone
Steady CW signal out put at power setting
To Stop either switch back to USB mode and Push VOX to off,
Or sometimes requires a power off/on to stop the CW transmitted signal
Next, same setup as above except the Sweep is turned off
Results in same problem.
Next, same setup as above except the VOX is turned off in USB
Cannot reproduce the bug.
Ron, NU1U
----- Original Message -----
From: "John Nason" <jmnason@yahoo.com>
To: <na9u@arrl.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Sunday, April 02, 2006 12:30 PM
Subject: [TenTec] Another O2 bug
> Here is another bug if anyone can confirm.
>
> I use the TT 706A microphone, I would be interested in
> knowing if other mikes do this:
>
> 1) Put the rig and the microphone on VOX while on USB
> or LSB. Make sure the 706A's vox light is on.
>
> 2) Then put the rig on UCW and whisper into the
> microphone or tap it to trigger a transmission.
>
> The rig will lock up transmitting in CW. I have not
> sent this one in yet. Anyone else?
>
> Thanks,
> John
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|