My OII does fail in this scenario. I just did a battery reset followed by a
master reset and it still fails.
My fails with just 3 steps:
1) Set NB to 2
2) Set NR to 2
3) Turn on manual notch and it fails.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Douglas Shock" <douglas.shock@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, April 02, 2006 11:27 PM
Subject: Re: [TenTec] Problem: Please confirm Orion II Radios
> Phil,
> Mine did the same. Do a abttery reset, then a master reset...the problem
> never occured again
>
> On 4/2/06, AI4DQ@aol.com <AI4DQ@aol.com> wrote:
> >
> > Version 2.032 software
> > When operating my new Orion II this am Had terrible Noise with NB set to
> > 2 ,
> > NR 3, Notch on and the SP set 3 and sweep on I then went notch
> > C position
> > rotating the Down from 1000HZ when I get past 900HZ I lose audio and
is
> > replaced with crackling sound The only way to restore the audio is by
> > turning the
> > radio off and on a reset is not required. I would like others to
confirm,
> > And I have one other owner confirm(WB4QDA) this Bug. and would
> > like everyone to
> > confirm this. I tried others setting but the NB has to be on and the NR
> > has
> > to be on as well as Notch.
> >
> > Phil AI4DQ
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|