I owned the Orion I with the built in LDG tuner, and now own an Orion II
with the LDG model OT-11P tuner. After engaging the tuner (e.g., the tuner
is active) and then changing bands, the Orion (both I & II models) turns off
the antenna matcher.
Ron, NU1U
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Grant Youngman
Sent: Saturday, April 01, 2006 14:44
To: 'Carl Moreschi'; 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] Orion II AT tuner question
> My guess on the tuner is that it goes into bypass mode when
> you do a band change. I'm going to ask TT.
I think I just verified that.
Tuned up MAIN, TX (VFO-A) on 1.8Mhz. Took an output reading at 28.0 Mhz on
the SUB (VFO-B). Changed bands on the transmitter (VFO-A) to 28 Mhz, and
the signal output on the sub receiver came up 12+ dB. That supports the
notion that the tuner goes into bypass on a band change unless you retune it
by transmitting into it. It didn't matter whether the tuner was retuned or
not to 28 Mhz.
Grant/NQ5T
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|