To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | [TenTec] [Fwd: Re: [Elecraft] K2 microphone advice] |
From: | ron <roncasa@verizon.net> |
Reply-to: | roncasa@verizon.net,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Thu, 02 Mar 2006 14:07:37 -0500 |
List-post: | <mailto:tentec@contesting.com> |
I thought this is really cool, that someone would make this recommendation on elecraft reflector. (and you guys complain about TT mikes, Ha!) smile Ron wb1hga message follows: Hi I use a TenTec 701 hand mike. It is a little smaller than the MH2 and comes with a 4 pin connector so you will need to go to Radio Shack and get an 8 pin connector and install it in place of the 4 pin. The interface is the same as the MH2 with the 5.6k resistor for bias required. Works good and is inexpensive ($28) Don Brown KD5NDB _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Which one ? PRO III or Orion, K4IA |
---|---|
Next by Date: | Re: [TenTec] Which one ? PRO III or Orion, Douglas Shock |
Previous by Thread: | [TenTec] RX EQ and TX EQ in 2055, Toby Pennington |
Next by Thread: | [TenTec] NR - Fact or Fiction?, Bill Tippett |
Indexes: | [Date] [Thread] [Top] [All Lists] |