Yep, I thought of that....
Much easier to cut the black and white wires in half, push the connector's
wires through the grommet, and solder the wires back together
Ron, NU1U (needed some excuse to use that soldering station)
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Jim Bobo
Sent: Sunday, February 26, 2006 15:25
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] LDG Tuner in Orion II?
What you have to do is pull the two coax cables throuth the grommet and
then the connector will go through. Then push the two coax cables back
through and reconnect them.
RM wrote:
>b. I couldn't get the connector through the front panel grommet; too tight
>(and I wouldn't recommend trying to force it through). I cut the connector
>leads, fed them through the grommet (front to back), and re soldered the
>white and black wires.
>
>
>
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|