hi robb,
thanks -- that's exactly how it acts, like I didn't plug a cable back in
properly. but I've checked that several times. won't hurt to check again
though. I should mention that everything else seems to be working properly.
just noise and no signals on the sweep...
I noted that the "main" and "sub" connectors are right together. I will
double check that this evening.
thanks!
kenb
--------------------
> > Ken,
>
> By chance, did you plug the logic board coax into the
> "main" connector, not the "sub" jack? I noticed that
> these connectors are close to each other and by not
> being careful, one could easily make an error.
> Just a thought as I did the mod over the weekend and
> agree that the documentation was excellent.
> Good luck, Robb N0RU
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|