TenTec
[Top] [All Lists]

Re: [TenTec] Triton IV Digital (544) Problem

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Triton IV Digital (544) Problem
From: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 20 Feb 2006 17:00:01 -0500
List-post: <mailto:tentec@contesting.com>
Have you ever once found a signal that was so weak that the tone covered up? 
Hook up an antenna before testing this.

Mike N4NT

----- Original Message ----- 
From: "Steve Garwood" <n0czv@willard-oh.com>
To: <tentec@contesting.com>
Sent: Monday, February 20, 2006 2:20 PM
Subject: [TenTec] Triton IV Digital (544) Problem


> I'm working on a TT 544 Digital that has a problem that I haven't tracked
> down a solution to yet:
>
>
>
> I am receiving a pulsating tone that is rather wide around 3.860 MHz.  It
> sounds just like the calibrator signal on an analog Triton IV, however 
> there
> is no calibrator in the digital version as far as I know.
>
>
>
> It would seem that it is most likely the counter that I may be hearing as
> there is no other processor type activity going on in the radio.  I'm
> hearing this signal on other bands - only once per band but not as loud.
>
>
>
> The strongest signal is in the 75 meter phone band.  The signal is loud
> audio wise, however there is no S-meter reading.
>
>
>
> Anyone seen this before...  Any thoughts?
>
>
>
> Thanks
>
>
>
> Steve, N0CZV
>
> Attica, Ohio
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>