Download the instructions for doing the v2 hardware mod. It has
detailed instructions on disassembly of the front panel.
Others have had luck temporarily fixing the rit encoder by pulling and
turning it.
73,
Alan N5NA
John (KE5C) wrote:
> I'm sure the factory can advise me, but they are not open today and I don't
> know
> about tomorrow (holiday), so I am wondering, has anyone replaced their Orion
> RIT
> (or any other) encoder? Mine has become intermittent, and I know a few other
> folks had the same problem, although they sent theirs in. I might not have
> even
> considered this, except most of the disassembly required is also necessary if
> you are doing your own control board modification to make best use of the V2
> firmware. I am stuck trying to figure out how to separate the encoder board
> from the front panel board. A pin header makes most of the connections, but
> something else is involved in holding this is place, and I think it has to do
> with some white spacers. Here are some pictures:
>
> http://www.bosshardradio.com/gallery/view_album.php?set_albumName=orion_rit
>
> Any ideas? Thanks if so! 73, John
>
>
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|