Hi Tim.
It sure does! You can even hear it slam on the right side of the meter
enclosure.
I have not heard of any broken needles though...
Bob.
-----Original Message-----
From: k3hx@juno.com [mailto:k3hx@juno.com]
Sent: Sat Feb 18 12:55:45 2006
To: tentec@contesting.com
Subject: Re: [TenTec] Orion meter pegging on CW TX
OM,
My concern is with the initial dit or dah, the meter needle slams
against the peg and then stays there as you noted.
73,
Tim
-- "Chortek, Robert L" <robert.chortek@berliner.com> wrote:
The needle on my Orion II goes to the peak value, whatever level that
may be depending on the power level, and holds at that peak while I
continue to xmit, without moving between dits and dahs. It is very nice.
Does yours work differently?
73,
Bob/AA6VB
Tim Wrote: When running at indicated PWR levels above "70" the meter
needle pegs to the right when the transmitter is keyed on CW. I'd be
grateful to know of a damping technique to remedy this.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
________________________________________________________________________
Try Juno Platinum for Free! Then, only $9.95/month!
Unlimited Internet Access with 1GB of Email Storage.
Visit http://www.juno.com/value to sign up today!
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|