Ken Simpson, W8EK wrote:
>TenTec items For Sale:
>
>TenTec 546 Omni D, series C, HF CW / SSB xcvr.
>All solid state, with up to 100 W output. The ALC can
>also be turned back with a front panel control for QRP
>operation. Covers 160 through 10 meters, including the
>10 MHz WARC band. Full QSK on CW, and a fantastic
>receiver. Terrific audio quality on SSB also. Built in audio
>CW filter. Digital read out. This one is in good shape,
>but has some wear around the audio gain control. With
>manual for $275.
>
>25 amp switching power supply
>This is a 25 amp switching power supply in a case that
>matches the early Omni series case, with the metal bezel
>around it. It is in a case that is the same size as a 243
>remote VFO. It has an ammeter on the front, along with
>Switch, TenTec logo, and output bulb. The front panel
>basically looks like a 280 power supply with a metal bezel,
>but says "Switcher/25" on it. It is very quiet, and well
>shielded, and does not produce any electrical noise that
>I could find. I am not positive if TenTec made this, or if it
>is homebrew to look like TenTec. If it is homebrew, it
>certainly is very professionally done. $120
>
>TenTec 299 Voice synthesized frequency counter
>This unit is used with the TenTec Omni 546 series A, B, C,
>some Argonauts, Corsair, and others. It will work with
>other rigs (such as the Triton), with minor mods to get
>the right connections.
>The 299 is used primarily for blind hams who can not read the
>frequency readout on the transceiver. By pushing a button, it
>will "speak" the frequency (to tenth of a KHz). A front panel
>switch permits selection of the entire frequency, or you can
>eliminate the MHz, and give only the KHz. There is also a
>volume control on the front panel.
>Of course it can also be used to give a "voice digital readout"
>to a rig with an analog dial.
>This particular unit is in great shape electrically. Cosmetically
>it has some wear, especially close to the button that is pushed
>to activate it. $ 190
>
>WARC band crystal for 24.5 MHz for Omni C $20
>
>TenTec 289 noise blanker for the Delta 580 transceiver
>This very effective noise blanker can be added the 580 Delta
>to help get rid of ignition noise, and is especially effective for
>mobile use. It is a rare item! $100
>
>TenTec 225 power supply
>This supply is made to match the Argosy transceiver. It supplies
>13.8 volts at up to 9 amps. This one is in very nice shape. I can
>not find a scratch on it. Paper work included for $95.
>
>Prices do not include shipping from Florida.
>
>Thanks.
>
>73,
>
>Ken, W8EK
>
>Ken Simpson
>E-mail to W8EK@speakeasy.net or W8EK@arrl.net
>Voice Phone (352) 732-8400
>
>
>
>
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
Hi Ken, do you still have the Omni, and if so how about $275.00 shipped?
Thanks,
Bill AB4KH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|