NO...AFSK is not better. IMHO it is an afforable solution on any modern rigs
in that you can go directly from an AUX jack into a soundcard. On the older
rigs, the only "reasonable" way for the average appliance opertator was
through the mic jack audio input.
I took this route over the weekend to avoid messing with soldering the aux
jack for fsk and then setting up my rigblaster pro.
On 2/13/06, Robert Tortajada <k2zc@rtort.com> wrote:
>
> I am just getting started in RTTY and will eventually get an O2 so i may
> be showing my ignorance here.
>
> From the limited I understand RTTY, it sounds like this is a AFSK
> issue. Doesn't the O2 support FSK? Or is there some reason why AFSK is
> better?
>
> Bob T
>
> RaySoifer@cs.com wrote:
>
> >I key the O2 using MMTTY just fine through the AUX cable, with the AUX
> input
> >level set to 75 and the VOX turned on and set for max sensitivity (with
> the
> >mic input disabled, of course). The exact settings you need will depend
> upon
> >your computer's headphone output level.
> >
> >Good luck,
> >
> >Ray W2RS
> >_______________________________________________
> >TenTec mailing list
> >TenTec@contesting.com
> >http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|