[TenTec] Mics

["Rob Atkinson, K5UJ" <k5uj@hotmail.com>]

the only sure fire way to figure out what a mic/rig is doing on-air is to 
buy or borrow a decent rx (rx bandwidth = to ur tx bandwidth and flat freq. 
response) put on cans and listen to yourself while you tx into a dummy load. 
 then switch to brief txing on antenna to listen for RF getting into audio. 
  most rig monitors take a feed off of the AF circuits; it's not an 
accurate representation of the final tx sound.  A good check rx is the TS870 
but anything you can get, even a cheap swl rx that has a bfo is usually 
better than an AF monitor.  of course it's ridiculous to buy a multi Kbuck 
rig for this so the next best thing is to get someone to make a mp3 
recording and email it to you.

BTW, AM is done partly for the _challenge_.   while SSB is in some ways 
technically more complicated, it has become an off the shelf hook everything 
together and go mode.   Doing AM well is much more difficult  and it helps 
to have no neighbors nearby, hi.

rob / k5uj

_________________________________________________________________
FREE pop-up blocking with the new MSN Toolbar ? get it now! 
http://toolbar.msn.click-url.com/go/onm00200415ave/direct/01/

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec