Chas,
If you need details of those antenna couplers, let me know as I have the
schematics and parts needed to build them. I was around in those years, and
earlier...
Ken, WA4RPH
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]On
Behalf Of Chas Nagel
Sent: Tuesday, January 31, 2006 5:26 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] openwire feed OT
Antenna transmission lines are always a subject of great interest. You
already have had some really good answers to your quiry below. In the 50's
when I entered into ham radio the OT that was breaking me in constructed for
me what was known at the time as an antenna coupler (now known mistakenly as
antenna tuner). It consisted of a large 2-gang capacitor mounted with
standoff insulators on a box which parallel tuned a coil with a center link
installed in the middle. I remember later adding a capacitor in the link.
The link was fed by 52 ohm coax from the rig. The coil assembly was plugged
into the top. It's hard to explain the physical configuration but you can't
buy most of the parts anymore anyway unless you are extremely lucky. Anyway,
the balanced open wire line or 300 ohm line was connected to the coil using
adjustable clips at optimum equal distances from each end of the coil until
a match was obtained in conjunction with tuning the capacitor. I wish I
still had that ma
tching
circuit but I don't think you can find it in any recent ARRL Handbook and
the parts are quite scarce. The coupler provided both a means of preserving
antenna balance and impedance matching. In those days there were many
physical designs some of which even permitted both series and parallel
feeder tuning. Just some history for you.
Enjoy.
Charles K0CW
Paul DeWitte K9OT <k9ot@mhtc.net> wrote:
I would like to reopen the discussion on getting open wire into the shack.
A while back there was quite a discussion on wheather to use a 4-1 or a 1-1
balun when going to coax from open wire outside the shack and then running
coax in to a tuner.
No one mentioned just hooking the coax direct to the open wire without a
balun.
First I realize that you are going from balanced to unbalanced. How would
this differ from feeding a dipole direct with coax and not using a balun at
the feed point?
I would like to put up a temporary loop and it is not feasable to run
openwire in to the shack. But I would like to feed it with open wire from
the loop to where it comes into the house (cheaper than buying more coax).
So I am looking for suggestions.
Since I am all T T it is only partly off topic.
Thanks
73 Paul K9OT
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.375 / Virus Database: 267.14.25/246 - Release Date: 1/30/06
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|