Barry -
Boards changed from early models are: (New boards listed are green).
Logic Bd, with VCXO, FM board with surface mtd components, also the control
board, first mixer, PBT board, IF/AF board. There are the most prominent.
Other boards may have changes that are not obvious from a general look
inside the rig. This is why I need an up-to-date manual.
Figure your own percentage (hi).
73 - Don
----- Original Message -----
From: "Barry Gross" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, January 22, 2006 11:50 AM
Subject: Re: [TenTec] OMNI 6+
> Has anyone looked inside a late Omni 6+ and can comment on what percentage
> of the boards use predominantly surface mount components? All the boards,
> only a few, etc?
>
> Thanks & 73,
> Barry N1EU
>
> On 1/22/06, ve1bn@ns.sympatico.ca <ve1bn@ns.sympatico.ca> wrote:
>>
>> Thanks for the info. I happen to have one of the late OMNI 6+
>> rigs with all the new boards and surface-mounted components
>> and with the VCXO factory done as you mentioned.
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|