TenTec
[Top] [All Lists]

[TenTec] Generator field current supply capacitor. Completely offtopic.

To: tentec@contesting.com
Subject: [TenTec] Generator field current supply capacitor. Completely offtopic.
From: Ken Brown <ken.d.brown@verizon.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 18 Jan 2006 19:35:30 -1000
List-post: <mailto:tentec@contesting.com>
Hi all,

There are so many knowledgeable people on this reflector, I'm sure 
someone will have the information I need.

I am repairing an old generator (alternator) set. I spliced the broken  
wire in one of the field coils, and replaced the diode bridge. I still 
need to replace the capacitor used in the DC supply from the diode 
bridge to the field coil. I don't know what value of capacitance to use. 
It is about an 8 kW 120/240 VAC alternator powered by an 1800 RPM single 
cylinder Diesel engine. The field coils (four coils in series) have a 
total series DC resistance of about 47 ohms. I was thinking that the RC 
time constant of the capacitor and the field coil resistance ought to be 
on the order of magnitude of about 1/60 of a second (to keep the field 
current flowing between cycles of the alternator output which feeds the 
diode bridge). However, if I calculate the capacitance needed to 
accomplish that, it comes out to hundreds of microfarads. With a voltage 
rating of 200 VDC this would be a sizeable capacitor, even with a modern 
capacitor. This is a 60 year old machine. The original old capacitor is 
about 1/2 inch diameter and an inch long. So my reasoning is clearly wrong.

Anyone with experience with generator sets that would know an 
appropriate capacitance value?

Thanks,

Ken N6KB

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Generator field current supply capacitor. Completely offtopic., Ken Brown <=