Ken -
The Paragon II can be easily discerned to be a "II" because it is easy
to see from the front panel right under the Ten-Tec logo. The original
Paragon just has "Paragon" on the front panel. This all you need to
distinguish them.
Saves digging around to see the label, wouldn't you say?
73 - Don
----- Original Message -----
From: "Ken Brown" <ken.d.brown@verizon.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, January 14, 2006 4:04 PM
Subject: Re: [TenTec] Paragon 585 vs 586
> You can determine whether it is a Paragon or a Paragon II by looking at
> the model and serial number label on the back panel. The original
> Paragon is model 585 and the Paragon II is model 586. I you cannot look
> at the rear panel, or if the label is missing, there are some
> differences on the front panel that will tell which Paragon it is. The
> original Paragon has a "label" function by which you can associate
> alphanumeric labels with memorized frequencies. There are silk screened
> letters next to most of the pushbuttons on the gray panel which
> surrounds the VFO knob. The Paragon II only has labels ON the buttons,
> NOT next to them.
>
> Regarding the "AM transmit " on the Paragon II, it is really SSB with
> reinserted carrier, and you can select which sideband you want to
> transmit. This is not the same AM produced by actually modulating an RF
> amplifier stage in the transmitter, and it also differs from most recent
> rigs which use a balanced modulator to produce DSB and then reinsert a
> carrier. Most rigs that have AM transmit mode these days use the usual
> balanced modulator to produce DSB. They either introduce a DC bias to
> the balanced modulator to unbalance it in order to let some carrier
> through, or the reinject the carrier in some later stage, all of this
> without passing the DSB through the sideband selecting filter. In the
> Paragon II the DSB from the balanced modulator does go through the
> sideband selecting filter. The carrier must be reinserted after the SSB
> filter. This results in a signal which can be demodulated by an AM
> detector with no BFO, yet quite different from typical AM. It is
> bandwidth limited by not just the audio circuitry, also by the SSB filter.
>
> DE N6KB
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|