-----Original Message-----
From: Barry LaZar [mailto:k3ndm@verizon.net]
Sent: Monday, January 09, 2006 10:20 AM
To: Duane A Calvin; k3ndm@arrl.net; tentec@contesting.com
Cc: tentec@contesting.com
Subject: Re: Re: [TenTec] Orion II Curiosity
Duane,
I have the power meter in line right after a good coax switch and
before a Tentec 300 watt dummy load that I used to test. I wanted to make
sure that both radios saw the same load.
I've had some interesting input that I need to double check. I'll do
that tonight, barring something unforseen. I'll post what I see. Thanks.
73,
Barry
K3NDM
>From: Duane A Calvin <ac5aa@juno.com>
>Date: Sun Jan 08 19:45:22 CST 2006
>To: k3ndm@arrl.net, tentec@contesting.com
>Cc: tentec@contesting.com
>Subject: Re: [TenTec] Orion II Curiosity
>Barry,
> It might help if you give more details on the meter, where it is
>placed and whether you have any SWR which might be reading differently on
>the Orion than on the TS-50. If you have a dummy load, have you tried
>driving it into that? Also, is your red ALC LED flashing on peaks like
>it should? Finally, an indication of where the Orion's power meter runs.
>
> Driving my Orion into a dummy load, my PowerMaster digital meter
>shows voice peaks at ~95W, and if I whistle, it reads 103-106W. ALC LED
>flashing on voice peaks, power meter reads 100 (does not follow voice
>peaks, one of the weaker items in the Orion design.) Hope this helps a
>little.
>
> 73, Duane
>
>
>On Sun, 08 Jan 2006 19:29:25 -0500 "Barry LaZar" <k3ndm@arrl.net> writes:
>> The way I'm lashed up here in the shack has a power meter
>> continuously on
>> line. I looked up to see how much I was putting out with the Orion
>> II and
>> discovered that I was showing about 35-50 watts average on SSB. I
>> changed
>> mode to CW and found I was putting out about 105-110 Watts.
>> I changed over to my Kenwood TS-50 which I have used to
>> reach out and touch
>> people all over the world to see what I would read with it. I
>> discovered
>> that the average was about 75 watts.
>> I went back to the Orion II to see if I missed something in
>> my setup, mic
>> gain or something. Nothing I played with seemed to allow me to kick
>> up more
>> power. I played with the speech processor and the mic gain. All I
>> could see
>> was that I was affecting the ALC, not much else. OK folks, what am
>> I
>> missing?
>>
>>
>>
>> 73,
>> Barry
>> K3NDM
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
>
>--------------------------------------
>Duane Calvin, AC5AA
>Austin, Texas
>
>http://home.austin.rr.com/ac5aa
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|