Several serial port problems were fixed and the sweep flat line problem and
S meter stopping were fixed. This version looks very good.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Joseph A. & Ruth O. Ryan" <ablee@bellsouth.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, January 09, 2006 11:12 PM
Subject: Re: [TenTec] 2.028 is out - error message
> So, its downloaded and installed....Carl, have you figured out what
> they, indeed, update?
> Or is it too soon to tell?
> 73', Joe, KX4JR
>
> At 10:57 PM 01/09/2006, you wrote:
> >When your flash utility first starts, select "Settings". In here you
will
> >be able to define which comport the Orion II is connected to. Once you
have
> >done this, then power off your OII. Then hold down the "recall" button
and
> >power on. Do not release the button until the OII says "Flash update
mode".
> >Once the OII is in flash update mode, click "Process" in the flash update
> >utility. This should get you going.
> >
> >Carl Moreschi N4PY
> >121 Little Bell Drive
> >Bell Mountain
> >Hays, NC 28635
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|