So, its downloaded and installed....Carl, have you figured out what
they, indeed, update?
Or is it too soon to tell?
73', Joe, KX4JR
At 10:57 PM 01/09/2006, you wrote:
>When your flash utility first starts, select "Settings". In here you will
>be able to define which comport the Orion II is connected to. Once you have
>done this, then power off your OII. Then hold down the "recall" button and
>power on. Do not release the button until the OII says "Flash update mode".
>Once the OII is in flash update mode, click "Process" in the flash update
>utility. This should get you going.
>
>Carl Moreschi N4PY
>121 Little Bell Drive
>Bell Mountain
>Hays, NC 28635
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|